- 您现在的位置：买卖IC网 > Sheet目录868 > LTM8042IV#PBF (Linear Technology)IC UMODULE LED DRIVER 56LGA
LTM8042/LTM8042-1
OPERATION
The LTM8042/LTM8042-1 is a complete, full featured,
current mode regulator specifically designed to drive light
emitting diodes (LEDs) or other loads where a constant cur-
rent up to 1A (350mA for the LTM8042-1) is required.
The LTM8042/LTM8042-1 can operate in any of three LED
drive topologies: boost, buck mode and buck-boost mode.
The device features both analog and PWM dimming, a PWM
P-channel MOSFET driver, and a suite of control functions:
RUN control, soft-start, user programmable switching
frequency, and external frequency synchronization.
Operation can be best understood by referring to the
Block Diagram. The power stage is a boost converter that
regulates the output current by reading the voltage across
a power sense resistor that is in series with the output.
As with any boost topology, there is an uninterrupted cur-
rent path between the input and output terminals. Current
between these two terminals is not limited, so the device
is intolerant to a short-circuit or overload from any of the
output terminals (LED + , BSTOUT/BKIN) to GND.
There are two ways to dim a LED with the LTM8042/
LTM8042-1. One way is to adjust the current on the LED
array by setting the analog voltage on the CTL pin. The
CTL pin is internally pulled up to a precision 2V reference
through a 1% 20k resistor. Leaving the CTL pin floating
sets the LED pin current to 1A. Reducing the voltage below
1.1V on the CTL pin proportionally reduces the current
flowing out of LED + . This can be accomplished by connect-
The other way the LTM8042/LTM8042-1 can dim a LED
array is by pulse width modulation using the PWM pin
and an optional external P-channel MOSFET. The external
P-channel MOSFET can be conveniently operated by the
integrated gate driver at pin TG. The gate drive function
can be enabled or disabled by the TGEN pin.
If the PWM pin is pulled high, the part operates nor-
mally. If the PWM pin is unconnected or pulled low, the
LTM8042/LTM8042-1 stops switching and the internal
control circuitry is held in its present state. This way, the
LTM8042/LTM8042-1 “remembers” the current sourced
from the LED + output until PWM is pulled high again.
This leads to a highly linear relationship between pulse
width and output light, allowing for a large and accurate
dimming range.
The RUN pin is used to deactivate the LTM8042/LTM8042-1.
When the RUN pin is pulled to a logic low state, the device
is shut down and draws typically less than 1μA of current.
The SS pin is used to limit inrush current during start-up.
The LTM8042/LTM8042-1 integrates a current source with
this function, so only a capacitor is necessary to establish
the soft-start characteristics of the output current.
The switching frequency is set by applying a single resistor
from the RT pin to GND, allowing operation anywhere from
250kHz to 2MHz, and the SYNC pin allows synchroniza-
tion to an external source between 300kHz and 2.5MHz.
ing a resistor from the CTL pin to GND, forming a divider
network with the internal 20k resistor, or by driving the
CTL pin directly to a voltage source, such as a DAC.
80421fa
15
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
LTM8048MPY#PBF
IC DC/DC UMODULE LDO BGA
LTM8052AEV#PBF
IC UMODULE 36VIN 5A CVCC 81LGA
M30R224K5
CAP CER 0.22UF 50V 10% RADIAL
M39014/22-0709
CAP CER 1000PF 100V 1% RADIAL
M41L0Q1U
JOYSTICK MINI 3AXIS W/BUTTON
M57140-01
CONV DC/DC ISO FOR IPM MOD
M57182N-315
CONV DC/DC HI-VOLT INPUT
M57184N-715B
CONV DC-DC STPDWN IPM 9-SIP
相关代理商/技术参数
LTM8042IV-1#PBF
功能描述:IC UMODULE LED DRIVER 56LGA RoHS:是 类别:电源 - 板载 >> LED 驱动器 - 恒定电流 系列:LTM8042 产品目录绘图:4015, 7021 Series 标准包装:25 系列:7021 BuckPlus 输入电压:5 ~ 32V 输出电压:2.5 ~ 29.5V 电流 - 输出:700mA 功率（瓦特）:22.4W 安装类型:通孔 端接类型:PCB 引脚 尺寸/尺寸:0.83" L x 0.83" W x 0.43" H（21.1mm x 21.1mm x 10.9mm） 工作温度:-40°C ~ 80°C 类型:降压，带调光 批准:- 其它名称:788-1018
LTM8042IV-1PBF
制造商:LINER 制造商全称:Linear Technology 功能描述:μModule Boost LED Driver and Current Source
LTM8042IVPBF
制造商:LINER 制造商全称:Linear Technology 功能描述:μModule Boost LED Driver and Current Source
LTM8045
制造商:LINER 制造商全称:Linear Technology 功能描述:Inverting or SEPIC ??Module DC/DC Converter with up to 700mA Output Current
LTM8045EY#PBF
制造商:Linear Technology 功能描述:DC-DC CONVRT +/-2.5V +/-15V 0.7A 制造商:Linear Technology 功能描述:DC-DC CONVERTER INVERTING/SEP 制造商:Linear Technology 功能描述:DC-DC CONVERTER, INVERTING/SEPIC, 2MHZ, 制造商:Linear Technology 功能描述:DC-DC CONVERTER, INVERTING/SEPIC, 2MHZ, BGA-40; Primary Input Voltage:18V; No. of Outputs:1; Output Current:700mA; No. of Pins:40; Operating Temperature Min:-40C; Operating Temperature Max:125C; Package / Case:40-BGA
LTM8045IY#PBF
制造商:Linear Technology 功能描述:Conv DC-DC Single Step Down/Step Up 2.8V to 18V uModule 40-Pin BGA 制造商:Linear Technology 功能描述:DC-DC CONVRT +/-2.5V +/-15V 0.7A 制造商:Linear Technology 功能描述:DC-DC CONVERTER INVERTING/SEP 制造商:Linear Technology 功能描述:DC-DC CONVERTER, INVERTING/SEPIC, 2MHZ, 制造商:Linear Technology 功能描述:DC-DC CONVERTER, INVERTING/SEPIC, 2MHZ, BGA-40; Primary Input Voltage:18V; No. of Outputs:1; Output Current:700mA; No. of Pins:40; Operating Temperature Min:-40C; Operating Temperature Max:125C; Package / Case:40-BGA
LTM8045MPY#PBF
制造商:Linear Technology 功能描述:DC-DC CONVRT +/-2.5V +/-15V 0.7A 制造商:Linear Technology 功能描述:SEPIC 2.8-18V 0.7A 2MHZ 2.5V 40BGA 制造商:Linear Technology 功能描述:DC-DC CONVERTER INVERTING/SEPIC 2MHZ 制造商:Linear Technology 功能描述:SEPIC, 2.8-18V, 0.7A, 2MHZ, 2.5V, 40BGA 制造商:Linear Technology 功能描述:DC-DC CONVERTER, INVERTING/SEPIC, 2MHZ, BGA-40, Primary Input Voltage:18V, No. of Outputs:1, Output Current:700mA, No. of Pins:40, Operating Temperature Min:-55C, Operating Temperature Max:125C, MSL:MSL 3 - 168 hours , RoHS Compliant: Yes
LTM8047
制造商:LINER 制造商全称:Linear Technology 功能描述:3.1VIN to 32VIN Isolated ??Module DC/DC Converter